1. during which process of the hydrologic cycle does the sun heat surface water, causing the water to change from its liquid state to its gaseous state?

a. infiltration
b. precipitation
c. condensation
d. evaporation

how does a closed lake differ from an open lake?

a. a closed lake has no outlet stream.
b. a closed lake contains standing water.
c. a closed lake contains fresh water.
d. a closed lake has no inlet stream
which criterion is not used to describe a mass movement event?

a. the rate at which the movement occurred
b. the motion of the failure
c. the angle of the slope
d. the type of material that failed

which of the following materials would likely create the strongest, most stable slope?

a. mudstone
b. sandstone
c. granite
d. unconsolidated sediment

in which location would the rate of soil erosion most likely be higher than the rate of soil formation?

a. a steep slope
b. a tropical area with moderate rainfall
c. a temperate forest
d. a river delta

1. D. Evaporation

2. A. A closed lake has no outlet stream.

3. C. The angle of the slope

4. C. Granite

Explanation:

1. The process through which water changes its state from liquid to gaseous is known as evaporation. A source of energy is required for this process to occur, energy that is provided by solar heat in this case. The opposite process in which water changes state from gas to liquid, is known as condensation. Precipitation is the process in which the condensed water reaches the Earth’s surface under the force of gravity. During infiltration, water on the ground surface enters the soil.  

2. A closed lake is defined by the lack of any outflow. Thus, any water that does not evaporate, will remain in this type of lake indefinitely.

3. The only criterion not used to describe a mass movement event is the angle of the slope. For such an event, the type of motion is the most important characteristic together with the physical characteristics of the material.

4. Granite is a highly consolidated material and thus it has a very high integrity. The other materials listed have inferior characteristics.

5. Soil erosion is a displacement process that occurs naturally though the action of water and wind. On a steep slope, no soil formation occurs, because, due to gravity, all the eroded material will be transported to another location. Thus, at the slope’s location, no soil formation occurs.

x would be the most and the least would be y because there are more fruit   and seeds than flock z has insects

which fault and or fold did you find most difficult to diagram